Festo AG & Co. KG
4080494
analogue output module
CPX-E-4AO-U-I
More detailed information about this product!
Festo Data sheet
Criterion | Feature |
Dimensions W x L x H | 18,9 mm x 76,6 mm x 124,3 mm |
Grid dimension | 18,9 mm |
No. of outputs | 4 |
Diagnostics via LED | Error per channel Error per module |
Diagnostics via bus | Short circuit/overload in actuator supply Short circuit/overload at analogue output parameterisation error Exceeding nominal range Value falls below nominal range Undervoltage in load supply General error |
Measured variable | Voltage Current |
Module parameters | Parameterisation error diagnostics Short circuit diagnostics for actuator supply Diagnostics for undervoltage in load supply Behaviour after short circuit/overload in actuator supply Behaviour after short circuit/overload at analogue output Deactivate actuator supply Data format analogue outputs |
Channel parameters | Signal range per channel Enable overload/short circuit diagnostics Enable wire break/idling diagnostics Release for parameterisation error diagnostics Force channel x |
Repetition accuracy | ±0.05% at 25 °C |
Protection (short circuit) | Internal electronic fuse protection per module |
Intrinsic current consumption at nominal operating voltage for electronics/sensors | typ. 60 mA |
Intrinsic current consumption at nominal operating voltage load | Typically 15 mA |
Operating error limit related to the ambient temperature range | ±0,3 % |
Basic error limit at 25°C | ±0,1 % |
Max. residual current outputs per module | 2 A |
Nominal operating voltage DC for electronics/sensors | 24 V |
Nominal operating voltage, DC outputs | 24 V |
Power failure buffering | 10 ms |
Electrical isolation channel – internal bus | Yes |
Electrical isolation channel – channel | No |
Permissible voltage fluctuations for electronics/sensors | ± 25 % |
Permissible voltage fluctuation, outputs | ± 25 % |
Power supply, type of connection | 2x terminal strips |
Power supply, connection technology | Cage clamp terminal |
Power supply, number of pins/wires | 4 |
Power supply, conductor diameter | 0,2 - 1,5 mm2 |
Power supply, note on conductor diameter | 0.2 - 2.5 mm² for flexible conductors without wire end sleeves |
Authorisation | RCM Mark |
CE mark (see declaration of conformity) | to EU directive for EMC |
Vibration resistance | Transport application test at severity level 1 in accordance with FN 942017-4 and EN 60068-2-6 |
Shock resistance | Shock test with severity level 1 in accordance with FN 942017-5 and EN 60068-2-27 |
Corrosion resistance classification CRC | 0 - No corrosion stress |
Storage temperature | -20 - 70 °C |
Relative air humidity | 95 % non-condensing |
Protection against direct and indirect contact | Protective extra-low voltage with safe disconnection (PELV) |
Protection class | IP20 |
Ambient temperature | -5 - 50 °C |
Note on ambient temperature | -5 - 60°C for vertical installation |
Product weight | 96 g |
Maximum address volume for outputs | 8 Byte |
Signal range | -10 - 10 V -20 - 20 mA -5 - 5 V 0 - 10 V 0 - 20 mA 4 - 20 mA |
Data format | 15 bits + prefix Linear scaling |
Max. line length | 30 m Shielded |
Electrical connection, output, function | Analogue output |
Electrical connection, output, connection type | 4x terminal strips |
Electrical connection, output, connection technology | Cage clamp terminal |
Electrical connection, output, number of pins/wires | 4 |
Electrical connection for output, conductor cross section | 0,2 - 1,5 mm2 |
Electrical connection for output, note on conductor cross section | 0.2 - 2.5 mm² for flexible conductors without wire end sleeves |
Electrical connection for output 2, function | Functional earth |
Electrical connection for output 2, connection type | Terminal strip |
Electrical connection for output 2, connection technology | Cage clamp terminal |
Electrical connection for output 2, number of pins/wires | 4 |
Electrical connection for output 2, connection pattern | 00995842 |
Electrical connection for output 2, conductor cross section | 0,2 - 1,5 mm2 |
Electrical connection for output 2, note on conductor cross section | 0.2 - 2.5 mm² for flexible conductors without wire end sleeves |
Mounting type | with top-hat rail |
Materials note | Contains PWIS substances Conforms to RoHS |
Material housing | PA |
© 2020 Festo AG & Co. KG