Festo AG & Co. KG
4080494
analogue output module
CPX-E-4AO-U-I
More detailed information about this product!
Festo Data sheet
| Criterion | Feature |
| Dimensions W x L x H | 18,9 mm x 76,6 mm x 124,3 mm |
| Grid dimension | 18,9 mm |
| No. of outputs | 4 |
| Diagnostics via LED | Error per channel Error per module |
| Diagnostics via bus | Short circuit/overload in actuator supply Short circuit/overload at analogue output parameterisation error Exceeding nominal range Value falls below nominal range Undervoltage in load supply General error |
| Measured variable | Voltage Current |
| Module parameters | Parameterisation error diagnostics Short circuit diagnostics for actuator supply Diagnostics for undervoltage in load supply Behaviour after short circuit/overload in actuator supply Behaviour after short circuit/overload at analogue output Deactivate actuator supply Data format analogue outputs |
| Channel parameters | Signal range per channel Enable overload/short circuit diagnostics Enable wire break/idling diagnostics Release for parameterisation error diagnostics Force channel x |
| Repetition accuracy | ±0.05% at 25 °C |
| Protection (short circuit) | Internal electronic fuse protection per module |
| Intrinsic current consumption at nominal operating voltage for electronics/sensors | typ. 60 mA |
| Intrinsic current consumption at nominal operating voltage load | Typically 15 mA |
| Operating error limit related to the ambient temperature range | ±0,3 % |
| Basic error limit at 25°C | ±0,1 % |
| Max. residual current outputs per module | 2 A |
| Nominal operating voltage DC for electronics/sensors | 24 V |
| Nominal operating voltage, DC outputs | 24 V |
| Power failure buffering | 10 ms |
| Electrical isolation channel – internal bus | Yes |
| Electrical isolation channel – channel | No |
| Permissible voltage fluctuations for electronics/sensors | ± 25 % |
| Permissible voltage fluctuations, load | ± 25 % |
| Power supply, type of connection | 2x terminal strips |
| Power supply, connection technology | Cage clamp terminal |
| Power supply, number of pins/wires | 4 |
| Power supply, conductor diameter | 0,2 - 1,5 mm2 |
| Power supply, note on conductor diameter | 0.2 - 2.5 mm² for flexible conductors without wire end sleeves |
| Authorisation | RCM Mark c UL us - Listed (OL) |
| KC mark | KC-EMV |
| CE mark (see declaration of conformity) | to EU directive for EMC |
| Certificate issuing department | UL E239998 |
| Vibration resistance | Transport application test at severity level 1 in accordance with FN 942017-4 and EN 60068-2-6 |
| Shock resistance | Shock test with severity level 1 in accordance with FN 942017-5 and EN 60068-2-27 |
| Corrosion resistance classification CRC | 0 - No corrosion stress |
| Storage temperature | -20 - 70 °C |
| Relative air humidity | 95 % non-condensing |
| Protection against direct and indirect contact | Protective extra-low voltage with safe disconnection (PELV) |
| Protection class | IP20 |
| Ambient temperature | -5 - 50 °C |
| Note on ambient temperature | -5 - 60°C for vertical installation |
| Product weight | 96 g |
| Maximum address volume for outputs | 8 Byte |
| Signal range | -10 - 10 V -20 - 20 mA -5 - 5 V 0 - 10 V 0 - 20 mA 4 - 20 mA |
| Data format | 15 bits + prefix Linear scaling |
| Max. line length | 30 m Shielded |
| Electrical connection, output, function | Analogue output |
| Electrical connection, output, connection type | 4x terminal strips |
| Electrical connection, output, connection technology | Cage clamp terminal |
| Electrical connection, output, number of pins/wires | 4 |
| Electrical connection for output, conductor cross section | 0,2 - 1,5 mm2 |
| Electrical connection for output, note on conductor cross section | 0.2 - 2.5 mm² for flexible conductors without wire end sleeves |
| Electrical connection for output 2, function | Functional earth |
| Electrical connection for output 2, connection type | Terminal strip |
| Electrical connection for output 2, connection technology | Cage clamp terminal |
| Electrical connection for output 2, number of pins/wires | 4 |
| Electrical connection for output 2, connection pattern | 00995842 |
| Electrical connection for output 2, conductor cross section | 0,2 - 1,5 mm2 |
| Electrical connection for output 2, note on conductor cross section | 0.2 - 2.5 mm² for flexible conductors without wire end sleeves |
| Mounting type | with top-hat rail |
| Materials note | Contains PWIS substances Conforms to RoHS |
| Material housing | PA |
© 2022 Festo AG & Co. KG